FieldServer X-25 Manual de usuario descargar pdf (Pagina 7)

FieldServer FS-X25 Start-Up Guide Page 7 of 12

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com

Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]m

3.1.2 DB-9 Pinouts for RS-485 Connection

Four Wire (full duplex multidrop)

Two Wire (1/2 duplex)

Note: The flow signals, RTS and CTS, should be connected as per diagram when unused to prevent loss of

performance on the FieldServer.

For users who do not wish to construct their own connector, we recommend using a DB-9 to screw block

connector which can be purchased from L-Com, Inc.

Item #: DGB9FT Ph: 1-800-341-5266 http://www.l-com.com/item.aspx?id=8141

3.2 Ethernet Connection

The FS-X25 Ethernet port automatically senses an uplink connection, and may therefore be connected to a PC or a

hub/switch using either a crossover cable (not supplied) or a direct Ethernet cable (supplied).

Figure 2: Ethernet Connection port

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

FieldServer X-25 Manual de usuario Pagina 7